jot@tiremagictpms.com +86-13423128830
English 
 |
FT718 Tucson
Tiremagic
| Support: | |
|---|---|
| Communication : | |
| Installation: | |
| Quantity: | |
Function
Remote start engine by original key or smart phone
Click 3 times Lock button, Car engine will be started.
Stop your engine by original key or smart phone
Click 3 times Lock button again, Car engine will be stopped.
Warm your car early in the winter by original key or smart phone
If your car turns on the air conditioner early,
when you start the car by remote start module,
you can also turn on the heat inside the car.
Pre-refrigerate your car in the summer by original key or smart phone
If your car turns on the air conditioner early, you can turn on the air conditioner when you start the car.
Step one by one when you Matching with car:
Step 1. Connect the A connector. Don't hit the
brakes, Click 2 times push button to ON
Notice: Pay attention to the LED status when you operate
Step 2. LED of main box will change to green
from Red, then turn off
Step 3 . Let push button of car OFF, Then
Remove cable A, then connect cable B
Step 4. Let push button of car ON again, Led
change to RED from Green, then off,
then Let Push button OFF again
Step 5 The matching is successful.
Re-set
long press Switch button of main box, then plug cable A into main box, then red led will blink, then release the Switch, re-set is successfull
Function
Remote start engine by original key or smart phone
Click 3 times Lock button, Car engine will be started.
Stop your engine by original key or smart phone
Click 3 times Lock button again, Car engine will be stopped.
Warm your car early in the winter by original key or smart phone
If your car turns on the air conditioner early,
when you start the car by remote start module,
you can also turn on the heat inside the car.
Pre-refrigerate your car in the summer by original key or smart phone
If your car turns on the air conditioner early, you can turn on the air conditioner when you start the car.
Step one by one when you Matching with car:
Step 1. Connect the A connector. Don't hit the
brakes, Click 2 times push button to ON
Notice: Pay attention to the LED status when you operate
Step 2. LED of main box will change to green
from Red, then turn off
Step 3 . Let push button of car OFF, Then
Remove cable A, then connect cable B
Step 4. Let push button of car ON again, Led
change to RED from Green, then off,
then Let Push button OFF again
Step 5 The matching is successful.
Re-set
long press Switch button of main box, then plug cable A into main box, then red led will blink, then release the Switch, re-set is successfull
